Border Gateway Protocol (BGP) Neighbor Configuration

What command specifies a BGP neighbor that has an IP address of 10.0.0.1 and that is in AS 500?

A. (config-router)# neighbor remote-as 500

B. (config-router)# network

C. (config-router)# router bgp 500

D. (config-router)# neighbor 500 remote-as

Answer:

The command used to specify a BGP neighbor that has an IP address and is in AS 500 is (config-router)# neighbor [IP address] remote-as 500, replacing '[IP address]' with the actual IP.

The command to specify a BGP (Border Gateway Protocol) neighbor that has an IP address and is in AS 500 is (config-router)# neighbor [IP address] remote-as 500. In this command, you would replace '[IP address]' with the actual IP address of the BGP neighbor. The 'remote-as 500' part of the command specifies that the IP address belongs to Autonomous System 500. BGP is a protocol that manages how packets are routed across the internet through the exchange of routing and reachability information among edge routers.