Setting Up a Connection to LAN-10: A Step-by-Step Guide
How can you set up a connection to LAN-10 using specific commands?
Follow the instructions provided to successfully establish a connection to LAN-10.
Step-by-Step Guide:
1. Access the interface Gigabit Ethernet 0/0 by entering the command R1(config)# interface GigabitEthernet 0/0.
2. Configure the description by entering the command R1(config-if)# description "Link to LAN-10".
3. Set the IP address 10.128.0.1/9 to the interface using the command R1(config-if)# ip address 10.128.0.1 255.255.255.128.
4. Activate the interface by entering the command R1(config-if)# no shutdown.
5. Exit the interface mode by entering the command R1(config-if)# exit.
Detail Explanation:
Setting up a connection to LAN-10 involves a series of specific commands that must be executed in the correct order. By following the steps outlined above, you can successfully configure the interface Gigabit Ethernet 0/0, assign the appropriate description, set the IP address, activate the interface, and exit the interface mode.
It is important to ensure that each command is entered accurately and that no abbreviations are used. By following these steps, you can establish a connection to LAN-10 and ensure smooth communication within your network.